This Temperature Cable Kit will fit a Hopper bin with a MINIMUM INSIDE HEIGHT from the top of the roof to the aeration in the cone of 44ft to a max of 47ft.

This kit includes: 1- 11 sensor cable, 1- 65ft interconnect & 1- Docking station.

11 Sensor Temperature Only Grain Bin Sensing Cable .

This cable mounts inside of the bin and is capable of monitoring Grain Temperature.

This cable is 43 feet long.

CABLE FITTING DIAGRAMS:

Need help figuring out which cable you need? See diagrams below.

HOW TO FIT YOUR HOPPER BIN WITH A CABLE:

TO FIND INTERCONNECT LENGTH (outside cable): Measure from the middle of your bin, to the edge (radius). Measure the full height of your bin. Add those 2 numbers together. This is your interconnect outside cable length. REFER TO GREEN ARROWS

TO FIND MOISTURE / TEMP CABLE LENGTH: Measure from the centre of the roof of your bin down to where your aeration starts. If you have a rocket, you may attach the cable inside the rocket. If you have horizontal aeration, you may tie the cable around it. REFER TO PINK ARROW.

THIS BIN REQUIRES A 5 SENSOR (20ft) CABLE WITH A 40FT INTERCONNECT OUTSIDE CABLE.

HOW T O FIT YOUR FLAT  BOTTOM BIN WITH A CABLE: 

TO FIND INTERCONNECT LENGTH (outside cable): Measure from the middle of your bin, to the edge (radius). Measure the full height of your bin. Add those 2 numbers together. This is your interconnect outside cable length. REFER TO GREEN ARROWS.                

TO FIND MOISTURE / TEMP CABLE LENGTH: Measure from the centre of the roof of your bin down to the floor. If you have an unload system, deduct another foot or two. REFER TO PINK ARROW.

THIS BIN REQUIRES A 3 SENSOR CABLE WITH A 20FT INTERCONNECT OUTSIDE CABLE.            

If this didn't help, feel free to CONTACT US!

65 Foot Interconnect Outside Cable .

This cable attaches to the inside sensing cable at the top of the bin. Interconnect cables extend the length of the bin along the outside to allow cable reading from the ground.

This cable is 65 feet long.

Bin Cable Docking Station .

The Docking Station protects the sensing cable from static electricity damage when not plugged in to a monitor. It is installed on to the grain bin and plugs in to the bottom of the interconnect cable.